MDS PREP
What is the typical polymer-to-monomer ratio required for denture base resin?
1) 1:1
2) 2:1
3) 3:1
4) 4:1
The accepted ratio of polymer to monomer for denture base resin is 3:1 volume, allowing sufficient wetting of the polymer particles.
What are the "sulfur granules" found in actinomycotic lesions?
1. Uric acid crystals
2. Coagulated pus cells
3. Calcified necrotic tisue
4. Colonies of the infecting organism
Pathology
Answer: 4
With Silicon Rubber Impression Materials
1. Three stone dies can be constructed
2. It is not possible to construct successive stone dies or casts
3. Four stone dies can be constructed
4. It is possible to construct successive stone dies or casts
Dental Material
Answer: 2
It is not possible to construct successive stone dies or casts with Silicon Rubber Impression Materials
Cyanosis of the lips is least likely to be seen in
1. iron deficiency anemia
2. congenital heart defects
3. polycythemia
4. cardiac congestion
Oral Pathology
Answer: 1
A patient on warfarin sodium following myocardial infarction reports for an oral surgical procedure. Which one of the following laboratory tests should be preferred to ascertain the fitness
1. Prothrombin time
2. Tourniquet time
3. Clotting time
4. Bleeding time
Oral Pathology
Answer: 1
Prothrombin time should be preferred to ascertain fitness for extraction in a patient on warfarin.