When a clasp is in place on the tooth, which of its parts should be active?
1. Retentive clasp terminal
2. Reciprocal clasp arm
3. Retentive clasp arm
4. None of the above
ProsthodonticsAnswer: 4
A non-soldered contilever spring bridge is considered to replace a missing upper central incisor when 1) There is sufficient spacing of the anterior teeth 2) There is steep palatal vault 3) When lower incisors are overerupted 4) All of the above
ProsthodonticsAnswer: 1
Thickness of wax in interocclusal records 1. 9 mm 2. 2 mm 3. 2 cm 4. 10 mm
ProsthodonticsAnswer: 2
All of the following are the border movements of the mandible in mid saggital plane except 1) Centric relation 2) Centric occlusion 3) Lateral contact position 4) Protrusive contact position
ProsthodonticsAnswer: 3
When patient closes in centric occlusion if lower jaw is placed anteriorly in relation to upper jaw, it is called as 1) Normal occlusion 2) Centric occlusion 3) Pre normal occlusion 4) Centric relation
ProsthodonticsAnswer: 3
Terminal component of clasp end is shaped as 1) Long 2) Stop 3) Finger 4) Arm
ProsthodonticsAnswer: 4
The important instruction you would like to give at the time of denture delivery is that 1) The denture may require relining in future 2) It is necessary to examine the tissues and the dentures periodically 3) It takes at least two weeks for the denture to settle down 4) It may result in excessive salivation
ProsthodonticsAnswer: 2
Which of the following finish lines may be difficult to detect on the tooth in an impression, or later on the die? I
1 Shoulder I
2. Knife-edge
3. Shoulder with bevel
4. Chamfer
